And I stumbled upon a post on the forum with the reference to this article… A providential chance! I’ve tried by all means to solve the problem with software, but without success. If you think it’s not the most appropriate model for compiling, don’t hesitate to let me know! Anyway, that’s what I’ve been doing since the beginning, and it works. I guess I can compile my projects with the DoIt ESP32 DevKit v1 model. The board I’ve been using so far seems to be free of this malfunction… But since I unpacked 3 other identical boards (that I bought at the same place), I’m now facing the problem.įor those who are interested, here are the boards I use: I admit I’ve never encountered this problem before. You may want to test this setup first on a breadboard to make sure it works for your ESP32 development board. To make your ESP32 board go into flashing/uploading mode automatically, you can connect a 10 uF electrolytic capacitor between the EN pin and GND. There is a way to fix this once for all – no need to hold down the “BOOT/FLASH” button anymore. But having to worry about this every time you want to upload new code can be tedious, specially when you’re testing and debugging your code.

One of the ways to solve this is holding-down the “ BOOT/FLASH” button in your ESP32 board while uploading a new sketch at the same time. This means that when you try to upload a new sketch to your ESP32, the Arduino IDE fails to connect to your board, and you get the following error message: Holding the BOOT/FLASH button Some ESP32 development boards (read Best ESP32 boards) don’t go into flashing/uploading mode automatically when uploading a new code. Learn how to fix the Fatal Error Occurred: “ Failed to connect to ESP32: Timed out waiting for packet header” error when trying to upload new code to your ESP32 board once for all.

Free download jtag pinout